EGW S&W Revolver Picatinny Rail Black

S&W Revolver Picatinny Rail Black

  5  In stock
Item No.: egw49100

This mount fits:
Smith & Wesson Revolver

Our mount will fit K, L, N, and X frames.

Once installed it enables you to mount a red-dot or pistol scope to your revolver.

The bolt pattern on this mount fits factory drilled Smith & Wesson revolvers.

Swing the cylinder out on your gun and look under the top strap. If you see the holes under the sight, through the top strap, your gun is factory drilled and tapped. Our mount fits snugly into the rear sight cut and has a recoil shoulder, unlike some mounts that are simply radiused to fit the top radius and do not go into the rear sight cut.

If your top strap is not already drilled and tapped (pictured above), our mount will not work with your gun. You can have a competent and qualified gunsmith drill and tap the top strap with the standard S&W hole pattern which will allow you to use our mount.

Rail Type: One Piece Picatinny
Machined from: Domestic 6061 T6 Extruded Aluminum
Finish: Matte Black Anodizing
Overall Length: 4.306"
Height: .4" (Top of Receiver to Top of Picatinny)
Weight: 2 oz.
Quick Disconnect Ring Compatible: No
Ambidextrous: Yes
Torque Specs: 20 in/lbs
Mounting Hardware: #6-48 X 1/4 Screws and T-10 Bit Included

EGW S&W Revolver Picatinny Rail Black does not have any reviews yet. Share your experiences and post a review.
EGW S&W Revolver Picatinny Rail Black

Article numbers