opc_loader
-->

          Create account

Brands
Products

VZ 58 receiver side rail light

VZ 58 receiver side rail with screws

(0 Reviews)
€58,00 €58,00 You Save: 0%
x
Stock
Stock:
  13  In stock
Item No.: CSA58-1-029L

The receiver side rail is manufactured in the Czech Republic and is attached to the receiver by two screws (two screws provided with rail). No template or drawings are provided with the side rail as it is not needed for installation. The side rail is pushed to the top of the receiver and is centered over the visible trigger pin. The receiver must be drilled and tapped.  

How to mount the side rail:

Center the side rail over the trigger pin (trigger pin in the receiver) using the cut-out in the side rail. Then push the side rail upwards (in the direction of the receiver cover). Using a drill press, center the drill bit in each hole of the side rail and drill into the receiver. The side rail will act as a guide to position your drill bit.

- drill bit size: 4.2mm diamter
- tap size: M5
- the hole closest to the barrel should be drilled to an approximate depth of 9.0mm (short screw is used in this hole), with older VZ58 you will go trough the receiver, this is not a problem.
- the hole closest to the buttstock will be completely drilled through the receiver wall (long screw is used in this hole)
- after tapping holes, use degreaser and secure side rail in place using high strength thread-locker on the two screws.

Drill bit and tap not included with side rail and screws.(AK type mounts will fit the side rail, but the vast majority of AK mounts will not allow proper ejection of shell casings.)

VZ 58 receiver side rail light does not have any reviews yet. Share your experiences and post a review.
Post review
VZ 58 receiver side rail light
Post review


Article numbers
EAN:
58-1-029L
SKU:
CSA58-1-029L

© 2022 Gunsmoke.eu

Gunsmoke webshop is part of Wapenhandel Podevijn