EGW CZ Shadow 2 Red Dot Mount Trijicon RMR/SRO and Holosun 407C/507C

Mounting Hardware is Included

Mounting Hardware:
(2) 6-32 Flat Head Screws
(1) 6-32 Set Screw

This mount fits:
CZ 75 Shadow
CZ 75 SP01 Shadow
CZ Shadow 2
Dan Wesson DWX
Dan Wesson DWX Compact

This mount does not fit:
Shadow 2 Optics Ready
Shadow 2 Kadet

Material: 7075 Aluminum
Coating: Matte Black Hardcoat
Overall Length: 1.780"
Overall Width: 1.1"
 

Our red dot sights are meant to be installed from the left to the right (with the muzzle facing forward). The dovetail has a progressive taper to allow for easier install.

Simply remove the rear sight on your gun and replace it with our mount in order to mount your Trijicon RMR or SRO / Holosun 407C/507C / Swampfox red-dot. You can take our mount off and replace your rear sight at any time. Mounting hardware included.

Installation Instructions
- Remove the rear sight*
- Install the EGW Sight Mount in the dovetail
- Tighten set screw (if applicable)
- Place the red dot sight on the EGW Sight Mount
(placing a small piece of paper between the red dot sight and the sight mount will make for easier removal and will keep Loctite off of the red dot sight.)
- Apply blue Loctite to the provided mounting screws
- Torque mounting screws to 15in/lbs

2 Flat Head Cap Screws - Provided for Trijicon RMR

The screws that are included with this mount require a 5/64'' allen wrench for installation.

Modification of your firearm may nullify the manufacturer's warranty.
This product should be installed and checked by a qualified gunsmith.
No liability is expressed or implied for damage or injury which may result from improper installation or use of this product.